05:58 pm
21 February 2019

DIY fabric printing, do it now

DIY fabric printing, do it now

Step One: Sketch out an image or a pattern you like on a piece of paper. You can then transfer this sketch to your linoleum block freehand, or you can use a pencil to fill in the reverse side of your sketch and then trace your image onto the block.

Luloveshandmade-DaWanda-Muttertag-8Step Two: Carve away what you don’t want to print. It can be a little tricky at first to figure out where the negative space lies if you are attempting line drawings. Solid fills and patterns are pretty easy to figure out, meanwhile. Take your time and be careful of your hands and fingers. One swift cut in the wrong direction can make a painful slice in your hand.

imagesStep Three: Once you’re satisfied with the look of your block, place some of your fabric ink on the cardboard. Roll the brayer to coat and distribute the ink evenly. Use the brayer to transfer the ink onto your block. Notice if there are inked areas outside of your image. You’ll want to carve those away so they don’t appear when you print.

I always like to test print on paper before I waste any fabric. Position your paper over your block and use the rollingindex pin to press the paper into block. Peel the paper off the block and take a peek. Do you need to make any adjustments? If you’re ready to print, repeat the above process using your fabric instead of paper. Once you’ve pressed the fabric into the block, carefully lift the fabric off the block and set aside to dry. Follow the directions noted on your fabric ink—some require heat-setting. Wash and dry according to direcimagestions. To enjoy such pleasure, the cheap 3D pen is an alternative.

A Step Further: If you’ve created a pattern, try playing with different colors or making a gradient by lightening your ink subtly as you fill your fabric.

What to do with your block printed fabric? Sew it into pillows. Make napkins. Stamp a flat bed sheet. Print tea towels. A cool tee-shirt. The possibilities are endless!